Generated by All in One SEO v5.0.0.1, this is an llms.txt file, used by LLMs to index the site.

# hbh7's Website

The Website of hbh7

## Sitemaps

- [XML Sitemap](https://hbh7.com/sitemap.xml): Contains all public & indexable URLs for this website.

## Posts

- [How to set up a WireGuard Site to Site VPN Between 2 EdgeRouters](https://hbh7.com/2018/09/30/setting-up-a-wireguard-site-to-site-vpn-between-2-edgerouters/) - How I linked my home and dorm networks with a WireGuard VPN using 2 EdgeRouters. Great speeds and only requires port forwarding on one side. How to Guide
- [Printer Cabinet](https://hbh7.com/2018/03/16/printer-cabinet/) - Possibly my first "big construction" project, this cabinet is built to hold my 3D printer, and my 2 2D printers below it.
- [RGB LED Controller Box Mount](https://hbh7.com/2018/03/20/rgb-led-controller-box-mount/) - I bought some LED strips off of eBay, and they have this massive controller box. For my printer cabinet, I designed this box that I could screw into the cabinet that would hold my LED controller for the LEDs along the top. Print Settings Printer: Monoprice Maker Select V2 Rafts: Doesn't Matter Supports: No Resolution: .2mm for speed Infill: 20%
- [Printer Cabinet iPhone 5s Mount](https://hbh7.com/2018/03/20/printer-cabinet-iphone-5s-mount/) - I designed this phone mount so I could slide my iPhone 5s into the right hand side and back out for easy removal. There's a small hole at the bottom middle for the charger to go through. The top and bottom pieces are simply double sided taped (the good stuff :P) to my printer cabinet,
- [3D Printing - Bundled Prints](https://hbh7.com/2017/11/15/3d-printing-bundled-prints/) - My Monoprice Maker Select V2 came with a few files on the SD card as sample prints, and a butterfly attached to the base as a factory calibration print I assume. Of course, I had to try out all the files. Here's how they came out. My Monoprice Maker Select V2 came with a few files
- [Monoprice Maker Select v2 3D Printer](https://hbh7.com/2017/11/15/monoprice-maker-select-v2-3d-printer/) - I've recently acquired a 3D Printer, specifically the Monoprice Maker Select v2. I've got it on my desk next to my monitor grid. In these pics, it has white PLA on it, a Benchy I printed, and a webcam pointed at it for time lapses and monitoring through Octoprint (on the laptop next to it)

## Categories

- [3D Printing](https://hbh7.com/category/3d-printing/)
- [Networking](https://hbh7.com/category/networking/)

## Tags

- [VPN](https://hbh7.com/tag/vpn/)
- [WireGuard](https://hbh7.com/tag/wireguard/)
- [Site to Site](https://hbh7.com/tag/site-to-site/)
- [EdgeRouter](https://hbh7.com/tag/edgerouter/)
- [Port Forwarding](https://hbh7.com/tag/port-forwarding/)
- [Firewall](https://hbh7.com/tag/firewall/)
- [guide](https://hbh7.com/tag/guide/)
- [how to](https://hbh7.com/tag/how-to/)